Saturday, September 6, 2014

Flat Track Knucklehead and Exhausted Panhead Project...

Gonna install my block off plate this weekend...I hope...

Figuring out rear pipe...raised trans causing issues

Adapted a later throttle angle tube to an old snap throttle


Took the easy way out and installed an old snap throttle kit...didn't like the way the cable runs into the side between the cylinders. So it all came apart and had to be re-engineered...

reworking a throttle control bracket

almost there...

Good!

Now I can run the cable in where it belongs 
utilizing the stock bracket...

Sizing things up...

Bird's eye view of the throttle control bracket....

Had to re-figure the spring and all that shit...

Fitting up the tank...all clear...

Slides by nicely and a cleaner approach...
The object is to keep the cable outta the way whilst racing

Had to lengthen the casing a bit

Connection made...

The splice in the casing is midway in the bracket...
This will hold both in place nicely...

Tape Time...I love Friction Tape!!!!

Oh yeah...in between I finished up Tyler's exhaust

Simple and clean...

Back to the Knuckle...more friction tape!

Moving on to the...whatever's next...

No comments:

Post a Comment