Panhead Project - Hummer Tail light

Using a Re-Pop Hummer tail light

The over all bracket seems to be heavier gauge than the original.

This will require slightly longer mounting screws to the fender...

The re-pop bullet cover looks OK...

Replaced the Taiwan bullet cover screws...as usual

In this case we're using 12-24 stainless "rack screws"

I had a few laying around...

We'll need to drill or grind some relief in the cover for the wiring harness, in that "U" section of the bullet cover bracket...

The wire they supply is crap but luckily it has a set screw type socket connection. We can run our wires straight up and in...

Taped off and marked for drilling...

using my old number plate to avoid tire damage.